1、檢查潤滑泵壓力是否在標準范圍，加油周期是否正常，儲油罐內油液面是

否在高低油位之間，少油則及時添加潤滑油。

   2、請及時排除空壓機及空氣過濾中的積水，并保持空氣過濾油杯中的油量充

足(油量占油杯2/3容積)。

   3、檢查氣壓表，確認壓力在6kg/cm2+0.5kg/cm以內。

   4、檢查主軸內錐孔空氣吹氣功能是否正常，并用擦拭棒擦拭主軸內錐孔。

   5、清潔刀柄、簡夾、刀具，并注意防銹處理。

   6、檢查電子手輪和操作面板表面是否有油污和雜物，隨時確保表面清潔。

   7、維持機器四周環境整潔，及時清理工作臺及導軌伸縮護罩周邊的鐵屑。

Maintenance instructions

Daily Maintenance

   1, check whether the pressure of the lubrication pump is in the standard range, whether the refueling cycle is normal, and the oil level in the storage tank is normal.

   If the oil level is between high and low, add lubricating oil in time if there is less oil.

   2, please remove the water in the air compressor and air filter in time, and keep the oil in the air filter oil cup full.

Enough (oil accounts for 2 / 3 of the oil cup volume).

   3, check the air pressure gauge, confirm that the pressure is within 6kg / cm2 + 0.5kg / cm.

   4, check the spindle inner cone hole air blowing function is normal, and wipe the spindle inner cone hole with a wiping stick.

   5, clean the handle, clip, tool, and pay attention to anti-rust treatment.

   6, check the electronic handwheel and operation panel surface whether there is oil and debris, at any time to ensure that the surface is clean.

   7, to maintain the machine around the environment clean, timely cleaning of the workbench and rail telescopic shield around the iron filings.